SIDE AIRBAG SENSOR (for Extra Cab) INSTALLATION

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY LH


    1. Turn the ignition switch off.

    2. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Install the side airbag sensor assembly LH with the nut.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the side airbag sensor assembly LH has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the side airbag sensor assembly LH, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    4. Check that the side airbag sensor assembly LH is not loose.

    5. Connect the connector.

  2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. CHECK SRS WARNING LIGHT

    Click here.