STEERING COLUMN ASSEMBLY REASSEMBLY

PROCEDURE

  1. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Entry and Start System)

    1. C302499N01

      Turn the ignition switch to ACC.

    2. Install the ignition switch lock cylinder assembly to the upper steering column bracket assembly.

    3. Make sure that the ignition switch lock cylinder assembly is securely installed to the upper steering column bracket assembly.

  2. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (w/o Entry and Start System)

    1. Engage the 2 claws to install the ignition or starter switch assembly to the upper steering column bracket assembly.

  3. INSTALL TRANSPONDER KEY COIL (w/o Entry and Start System)

    1. Engage the 2 claws to install the transponder key coil.

  4. INSTALL UPPER STEERING COLUMN BRACKET WITH SWITCH ASSEMBLY (w/o Entry and Start System)

    1. Secure the steering column assembly in a vise between aluminum plates.

      Note:

      Do not overtighten the vise.

    2. C303946

      Temporarily install the upper steering column bracket with switch assembly with a new steering lock set bolt.

    3. Tighten the steering lock set bolt until the bolt head breaks off.

  5. INSTALL STEERING LOCK ACTUATOR ASSEMBLY (w/ Entry and Start System)

    Tip:

    • Perform the same procedure as for the upper steering column bracket with switch assembly.

    • When replacing the steering lock actuator assembly, refer to Service Bulletin.

  6. INSTALL NO. 1 STEERING COLUMN PROTECTOR (for Manual Transaxle RHD)

    1. Install the No. 1 steering column protector with the bolt.

      25.0 N*m

      255 kgf*cm

      18 ft.*lbf