СТАРТЕР СНЯТИЕ

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the starter assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Battery terminal is disconnected/reconnected Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point Panoramic view monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Initialize servo motor Air conditioning system

Click here

Reset slide door close position Power slide door system

Click here

Reset back door close position Power back door system

Click here

Replacement of starter assembly Clear Number of Starter Operations Stop and start system

Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. SEPARATE CENTER NO. 1 COWL TOP VENTILATOR LOUVER

    Click here

  4. REMOVE BATTERY


    1. B006O6PC01
      *a Clamp
      *b Guide

      Disengage the 2 claws to open the battery terminal cap.

    2. Loosen the nut and disconnect the cable from the positive (+) battery terminal.

    3. Disengage the clamp and guide from the battery clamp sub-assembly.

    4. B006M9M

      Remove the bolt, nut and battery clamp sub-assembly.

    5. B006RCD

      Remove the battery insulator from the battery.

    6. Remove the battery and battery tray.

    7. B006QTC

      Remove the battery clamp bolt from the battery carrier.

  5. REMOVE BATTERY CARRIER


    1. B006P2E

      Disengage the 2 clamps.

    2. Remove the 5 bolts and battery carrier.

  6. REMOVE BATTERY CARRIER SUPPORT


    1. B006P5C

      Remove the 2 bolts and battery carrier support.

  7. REMOVE STARTER ASSEMBLY


    1. B006R03C01
      *1 Terminal Cap
      *2 Wire Harness Clamp Bracket

      Remove the terminal cap.

    2. Remove the nut and disconnect terminal 30.

    3. Disconnect the starter assembly connector.

    4. Remove the bolt and disconnect the wire harness clamp bracket.

    5. Remove the 2 bolts and starter assembly.