SHIFT AND SELECT LEVER SHAFT DISASSEMBLY

PROCEDURE

  1. REMOVE INNER NO. 2 SHIFT LEVER

    1. Secure the shift and select lever shaft assembly in a vise between aluminum plates.

    2. C193736

      Using a 5 mm pin punch and hammer, remove the slotted spring pin and inner No. 2 shift lever from the shift and select lever shaft.

      Tip:

      Make a note of the orientation of the inner No. 2 shift lever so that it can be reinstalled in the same position.

  2. REMOVE RELEASE HEAD STRAIGHT PIN

    1. C193737

      Using a 5 mm pin punch and hammer, remove the slotted spring pin from the select stopper block.

    2. C193738

      Using a 5 mm pin punch and hammer, remove the slotted spring pin from the front inner shift lever.

    3. C193740

      Turn the release head clockwise.

    4. C193741

      Slide the select stopper block upwards and remove the release head straight pin from the front inner shift lever.

  3. REMOVE SELECT STOPPER BLOCK

    1. C195248

      Remove the front inner shift lever, release head torsion spring, release head and select stopper block from the shift and select lever shaft.

      Tip:

      Make a note of the orientation of the front inner shift lever, release head torsion spring, release head and select stopper block so that they can be reinstalled in the same position.