COMBINATION METER REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. DISABLE AUTOAWAY/RETURN FUNCTION (for Power Tilt and Power Telescopic Steering Column)

   
   

   1. Disable the autoaway/return function by changing the customize parameter.

      Click here

      CAUTION:

      Record the current customize parameter setting (whether the autoaway/return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the autoaway/return function to be disabled when the engine switch is turned off.

   2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

   3. Turn the engine switch off.

2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH (for RHD)

   Click here

3. REMOVE COWL SIDE TRIM BOARD RH (for RHD)

   Click here

4. REMOVE CONSOLE ARMREST ASSEMBLY

   Click here

5. REMOVE UPPER REAR CONSOLE PANEL

   Click here

6. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH

   Click here

7. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH

   Click here

8. REMOVE INSTRUMENT SIDE PANEL LH

   Click here

9. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

   Click here

10. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

11. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

12. REMOVE NO. 1 SWITCH HOLE BASE

    Click here

13. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

14. REMOVE NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

15. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

    Click here

16. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

17. REMOVE COMBINATION METER ASSEMBLY

    
    
    1. 

       *1

       Screw

       Remove the 4 screws.

    2. Disconnect the connectors, detach the clamp and remove the combination meter assembly.