REAR AXLE HUB ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. REMOVE REAR WHEEL

  2. DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

    Click hereClick here

  3. REMOVE REAR DISC

    Click hereClick here

  4. INSPECT REAR AXLE HUB BEARING LOOSENESS

    1. C130656

      Using a dial indicator, check for looseness near the center of the axle hub.

      Maximum

      0.05 mm (0.00197 in.)

      Note:

      Make sure that the dial indicator is set perpendicular to the measurement surface.

      If the looseness is more than the maximum, replace the axle hub assembly.

  5. INSPECT REAR AXLE HUB RUNOUT

    1. C202386

      Using a dial indicator, check for runout on the surface of the axle hub inside the rear axle hub bolt.

      Maximum

      for 2WD: 0.08 mm (0.00315 in.)

      for 4WD/AWD: 0.06 mm (0.00236 in.)

      Note:

      Make sure that the dial indicator is set perpendicular to the measurement surface.

      If the looseness is more than the maximum, replace the axle hub assembly.

  6. INSTALL REAR DISC

    Click hereClick here

  7. CONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

    Click hereClick here

  8. INSPECT AND ADJUST PARKING BRAKE

    Click here

  9. INSTALL REAR WHEEL

    103 N*m

    1050 kgf*cm

    76 ft.*lbf