ROCKER OUTER PANEL CUT AND JOIN REPLACEMENT SECTIONS (SMALL AREAS)

B0083A2

  1. REMOVAL

    Symbol Meaning
    B00837V Remove Weld Points
    B00839L Cut and Join Location
    B00839F Cut Location for Supply Parts
    B008391
    B0083AGC01
    *a 100 mm (3.94 in.) - -

    1. When replace only the outer panel, please cut off a necessary range depending on a damage range.


      1. Carefully cut the outer panel so not to damage the reinforcement.

      2. Make sure that butt welding does not heat-affect the reinforcement when welding the outer panel.

  2. INSTALLATION

    Symbol Meaning
    B008397 Plug Weld
    B0083AI Butt Weld

    1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

    2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

      B008375C01
      *1 ROCKER PANEL OUTER - -

    3. After welding, apply body sealer to the corresponding parts. (See the painting/coating)

    4. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.