ACTIVE STABILIZER SUSPENSION SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips

Use these procedures to troubleshoot the active stabilizer suspension system.

*: Use the GTS.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. PROBLEM SYMPTOM CONFIRMATION

    Result
    Proceed to
    NEXT

    NEXT

  3. INSPECT BATTERY


    1. Measure the voltage of the battery.

      Standard voltage
      11 to 14 V (Engine switch off)

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

      Result
      Proceed to
      NEXT

    NEXT

  4. CHECK FOR DTC*


    1. Check for all DTCs.

      Result
      Result Proceed to
      DTC is output. A
      CAN communication system DTC is output. B
      DTC is not output. C

      Tech Tips

      If a CAN communication trouble code is output, troubleshoot that code before performing repairs on this system.


    B

    GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here

    C

    USE SIMULATION METHOD TO CHECK Click here

    A

  5. REPAIR OR REPLACE


    1. Before performing repairs or replacement, refer to PRECAUTION.

      Click here

    2. Refer to the DIAGNOSTIC TROUBLE CODE CHART and perform repairs.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  6. CONFIRMATION TEST


    1. Perform the OPERATION CHECK.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

    END