FRONT DOOR BELT MOULDING REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE DECK BOARD ASSEMBLY

    Click here

  3. REMOVE NO. 1 DECK BOARD

    Click here

  4. REMOVE NO. 2 DECK BOARD

    Click here

  5. REMOVE REAR DECK FLOOR BOX

    Click here

  6. REMOVE DECK FLOOR BOX RH

    Click here

  7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  9. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  10. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  11. REMOVE DOOR ARMREST COVER

    Click here

  12. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  13. REMOVE FRONT DOOR TRIM BRACKET

    Click here

  14. REMOVE FRONT DOOR SERVICE HOLE COVER

    Click here

  15. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  16. REMOVE FRONT DOOR GLASS RUN

    Click here

  17. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY


    1. A005EWQE01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the front door belt moulding assembly.

    2. A0059OGE03
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, disengage the 7 claws and remove the front door belt moulding assembly.

      Tech Tips

      Tape the screwdriver tip before use.