8NR-FTS BATTERY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the battery removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	Lane departure alert system (w/ Steering Control)	Click here
		Simple intelligent parking assist system*1
		Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
		Pre-collision system
	Initialize back door lock	Power door lock control system	Click here
	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system*2	Click here
Replacement of battery	Clear the integrated current value Switch battery type	Stop and start system*2	Click here

*1: When performing learning using the GTS.
Click here Click here
*2: w/ Stop and start system

PROCEDURE

PRECAUTION

Note

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
1. Loosen the nut and disconnect the cable from the negative (-) battery terminal.
  
  Note
  
  When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
  
  Click here
REMOVE BATTERY
1. Disengage the 2 claws to remove the fusible link cover.
2. Loosen the nut.
3. Disengage the clamp and disconnect the cable from the positive (+) battery terminal.
4. Remove the battery insulator from the battery.
5. Remove the bolt and No. 2 battery clamp.
6. Remove the battery from the vehicle.