REAR TRAILING ARM INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. INSTALL REAR TRAILING ARM ASSEMBLY

    1. Using a jack and wooden block, keep the rear No. 2 suspension arm assembly level.

      CAUTION:

      Do not jack up the rear No. 2 suspension arm assembly too high as the vehicle may fall.

      Note:

      • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.

      • Make sure to perform this operation with the vehicle kept as low as possible.

    2. C211908C01
      V100135

      Bolt (A)
      V100136

      Bolt (B)

      Install the rear trailing arm assembly with the 2 bolts (B) and 2 bolts (A).

      Bolt (A)

      200 N*m

      2039 kgf*cm

      148 ft.*lbf

      Bolt (B)

      90 N*m

      918 kgf*cm

      66 ft.*lbf

  2. TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY

    1. Using the rear suspension toe adjust cam sub-assembly, rear No. 1 suspension camber adjust cam and nut, temporarily install the rear No. 1 suspension arm assembly to the rear suspension member sub-assembly.

      Note:

      • Insert the rear suspension toe adjust cam sub-assembly from the rear of the vehicle.

      • Hold the rear suspension toe adjust cam sub-assembly while rotating the nut.

  3. INSTALL SKID CONTROL SENSOR WIRE

    1. C270486C02

      *a

      Clamp

      *b

      Guide

      Install the skid control sensor wire to the rear trailing arm assembly with the bolt and clamp.

      8.0 N*m

      82 kgf*cm

      71 in.*lbf

      Note:

      • Do not twist the skid control sensor wire when installing it.

      • Make sure that the guide of the skid control sensor wire is inserted.

  4. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY

    1. Install the No. 3 parking brake cable assembly with the 3 bolts.

      6.0 N*m

      61 kgf*cm

      53 in.*lbf

      C272541C02

      *a

      Guide

      -

      -
      Note:

      • Do not twist the No. 3 parking brake cable assembly when installing it.

      • Make sure that the 3 guides of the No. 3 parking brake cable assembly are inserted.

  5. INSTALL REAR FLOOR SIDE MEMBER COVER LH (for LH Side)

    Click hereClick hereClick here

  6. INSTALL REAR FLOOR SIDE MEMBER COVER RH (for RH Side)

    Click hereClick hereClick here

  7. INSTALL REAR SUSPENSION ARM COVER

    Click here

  8. INSTALL REAR WHEEL

    103 N*m

    1050 kgf*cm

    76 ft.*lbf

  9. FULLY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY

    Click here

  10. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click hereClick hereClick hereClick here