FRONT DOOR BELT MOULDING INSTALLATION

PROCEDURE

1. PRECAUTION

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

2. INSTALL FRONT DOOR BELT MOULDING ASSEMBLY

   
   

   1. 

      Engage the 7 claws to install the front door belt moulding assembly.

3. INSTALL FRONT DOOR GLASS RUN

   Click here

4. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

   Click here

5. INSTALL FRONT DOOR SERVICE HOLE COVER

   Click here

6. INSTALL FRONT DOOR TRIM BRACKET

   Click here

7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

   Click here

8. INSTALL DOOR ARMREST COVER

   Click here

9. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

   Click here

10. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

11. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

12. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

13. INSTALL DECK FLOOR BOX RH

    Click here

14. INSTALL REAR DECK FLOOR BOX

    Click here

15. INSTALL NO. 1 DECK BOARD

    Click here

16. INSTALL NO. 2 DECK BOARD

    Click here

17. INSTALL DECK BOARD ASSEMBLY

    Click here

18. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

19. INSPECT POWER WINDOW OPERATION

    Click here