ДАТЧИК ПОЛОЖЕНИЯ ПАРКИНГА / НЕЙТРАЛИ СНЯТИЕ


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE FRONT EXHAUST PIPE ASSEMBLY (w/ DPF)


    1. Отсоедините разъем датчика температуры отработавших газов и открепите зажим.

    2. Отсоедините разъем датчика температуры отработавших газов № 2 и открепите 2 зажима.

    3. Отсоедините разъем датчика температуры отработавших газов № 3 и открепите 2 зажима.

    4. B007T94

      Отсоедините воздушный шланг выпускной трубы № 1 и воздушный шланг выпускной трубы № 7 от приемной трубы.

    5. B007U9D

      Снимите опоры выпускной трубы № 2 и № 4.

    6. Отверните 3 гайки и снимите приемную трубу.

    7. Снимите прокладку.

  3. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Set the shift lever to the neutral position.

    2. B007UJWE01

      Remove the nut from the control shaft lever.

    3. Remove the clip and disconnect the control cable from the control cable bracket.

  4. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. B007OM3E01

      Disconnect the park/neutral position switch connector.

    2. B007QO5E03

      Using a screwdriver, pry out the lock washer.

    3. Remove the lock nut and lock washer.

    4. B007V6Y

      Remove the bolt and park/neutral position switch.

      Tech Tips

      Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.