BRAKE BOOSTER(for RHD) REMOVAL

CAUTION / NOTICE / HINT

Note:

Make sure to release vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.

PROCEDURE

  1. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

    Click here

  2. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Instrument Panel Under Cover)

    for Sedan:Click hereClick here

    for Hatchback, Wagon:Click here

  3. REMOVE SECURITY HORN ASSEMBLY (w/ Security Horn)

    Click here

  4. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY (for Manual Transaxle)

    Click here

  5. REMOVE BRAKE PEDAL RETURN SPRING

    Click here

  6. LOOSEN LOCK NUT

    1. C142634C01

      *1

      Lock Nut

      *2

      Brake Master Cylinder Push Rod Clevis

      Loosen the lock nut of the brake master cylinder push rod clevis.

  7. REMOVE PUSH ROD PIN

    Click here

  8. DISCONNECT CHECK VALVE TO CONNECTOR TUBE HOSE

    1. C273667

      Slide the clip and disconnect the check valve to connector tube hose from the brake booster assembly.

  9. REMOVE NO. 2 BRAKE TUBE CLAMP

    1. for 1NR-FE, 1WW

      1. C273669

        Disengage the clamp to remove the No. 2 brake tube clamp.

    2. for 1ZR-FAE:

      1. C273670

        Disengage the clamp to remove the No. 2 brake tube clamp.

      2. C273671

        Disengage the claw to remove the brake tube heat insulator from the No. 2 brake tube clamp.

    3. for 1ND-TV, 8NR-FTS:

      1. C326529

        Disengage the 3 claws to remove the brake tube heat insulator from the No. 2 brake tube clamp and No. 3 brake tube clamp.

      2. C273669

        Disengage the clamp to remove the No. 2 brake tube clamp.

  10. REMOVE NO. 3 BRAKE TUBE CLAMP (for 1ND-TV, 8NR-FTS)

    1. C331194

      Disengage the clamp to remove the No. 3 brake tube clamp.

  11. REMOVE BRAKE BOOSTER ASSEMBLY

    1. C273668

      w/ Stop and Start System:

      Disconnect the connector from the vacuum sensor assembly.

    2. C269484

      Remove the 4 nuts and push the brake booster assembly toward the engine compartment.

      Note:

      Do not apply excessive force to the brake lines.

    3. Remove the brake master cylinder push rod clevis and lock nut from the brake booster assembly.

    4. Remove the brake booster assembly from the vehicle body.

      Note:

      Do not apply excessive force to the brake lines or refrigerant lines.

  12. REMOVE BRAKE BOOSTER GASKET