METER / GAUGE SYSTEM Entire Combination Meter does not Operate

WIRING DIAGRAM

B007VXHE08

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK COMBINATION METER ASSEMBLY (COMBINATION METER ASSEMBLY - BATTERY AND BODY GROUND)


    1. B007PB0E24
      Text in Illustration
      *a

      Rear view of wire harness connector

      (to to Combination Meter Assembly)

      Disconnect the combination meter assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H20-21 (E1) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      H20-1 (L) - Body ground Always 11 to 14 V
      H20-2 (IG+) - Body ground Ignition switch ON 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE COMBINATION METER ASSEMBLY Click here