BRAKE BOOSTER(for LHD) REMOVAL

CAUTION / NOTICE / HINT

Note:

Make sure to release vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.

PROCEDURE

  1. REMOVE BRAKE ACTUATOR WITH BRACKET

    Click here

  2. REMOVE VACUUM HOSE ASSEMBLY

    1. Disconnect the vacuum hose assembly from the brake booster assembly.

      C398282C01

      *a

      Vacuum Hose Assembly Connector

      *b

      Retainer
      V100136

      Pinch

      		 V100137

      Pull Off

    2. Disengage the clamp to separate the vacuum hose assembly.

    3. Pinch the retainer of the vacuum hose assembly connector, and then pull the vacuum hose assembly connector off of the intake manifold.

  3. REMOVE PUSH ROD PIN

    Click here

  4. REMOVE BRAKE BOOSTER ASSEMBLY

    1. C302760

      w/ Stop and Start System:

      1. Disconnect the connector from the vacuum sensor assembly.

    2. C302704

      Remove the 4 nuts and brake booster assembly.

      Note:

      Do not apply excessive force to the brake lines.

  5. REMOVE BRAKE BOOSTER GASKET