UNDER BODY REFERENCE VALUES THREE-DIMENSIONAL DISTANCE

Tip:

Measure points with the engine under cover no. 1, engine under cover no. 2 and front floor cover removed.
In cases in which only one dimension is given, left and right are symmetrical.
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).

Table 1. Measuring Point Name
Symbol	Name	Hole Diameter mm (in.)
A, a	Radiator Cover Plate Standard Hole	φ10 (0.39)
B, b	Side Rail Reinforcement Installation Bolt	M10 (0.39)
C, c	Front Suspension Crossmember Installation Bolt	M14 (0.55)
D, d	Front Suspension Crossmember Installation Bolt	M14 (0.55)
E, e	Front Side Inner Rear Member Standard Hole	φ18 (0.71)