FRONT DOOR LOCK INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart.

    Click here

PROCEDURE

  1. INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

    Click here

  2. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH

    Click here

  3. INSTALL FRONT DOOR WITH MOTOR LOCK ASSEMBLY LH

    Note:

    • When reusing the removed front door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

    • Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.

    • Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion. This may result in a malfunction of the front door lock assembly.

    1. Apply MP grease to the sliding parts of the front door with motor lock assembly LH.

    2. B337013

      Install a new door lock wiring harness seal to the front door with motor lock assembly LH.

    3. B337017C01

      *1

      Front Door Lock Open Rod LH
      V100135

      Upward

      Insert the front door lock open rod LH into the front door with motor lock assembly LH.

    4. Make sure that the front door lock open rod is securely connected to the front door with motor lock assembly LH.

    5. B337011C03

      *A

      w/o Double Locking System

      *B

      w/ Double Locking System

      Using a T30 "TORX" socket wrench, install the front door with motor lock assembly LH with the 3 screws.

      5.0 N*m

      51 kgf*cm

      44 in.*lbf

    6. Connect the connector.

  4. INSTALL FRONT DOOR OUTSIDE HANDLE COVER LH (for Driver Side)

    Click here

  5. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

    Click here

  6. INSTALL FRONT DOOR GLASS RUN LH

    Click here

  7. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  8. INSTALL FRONT DOOR SERVICE HOLE COVER LH

    Click here

  9. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  10. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  11. INSTALL DOOR ASSIST GRIP COVER LH

    Click here

  12. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  13. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  14. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick hereClick here

  16. CHECK SRS WARNING LIGHT (w/ Side Airbag)

    Click here

  17. INITIALIZE POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function)

    Click hereClick here

  18. CHECK POWER WINDOW CONTROL SYSTEM

    Click hereClick here

  19. CHECK POWER DOOR LOCK CONTROL SYSTEM

    Click hereClick here