TIRE PRESSURE WARNING SYSTEM, Diagnostic DTC:C2198/98

DTC Code DTC Name
C2198/98 Initialization Switch (for Test Mode DTC)

DESCRIPTION

During test mode, when the tire pressure warning reset switch is on, the tire pressure warning light comes on and when the tire pressure warning reset switch is off, the tire pressure warning light blinks at 0.125 second intervals.

DTC No.

DTC Detection Condition

Trouble Area

C2198/98

Test mode procedure is performed.

  • Tire pressure warning reset switch

  • Harness or connector

  • Tire pressure warning ECU and receiver

WIRING DIAGRAM

C249283E19

CAUTION / NOTICE / HINT

Note:

  • When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

  • It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.

PROCEDURE

  1. INSPECT TIRE PRESSURE WARNING RESET SWITCH

    1. Remove the tire pressure warning reset switch (Click here).

    2. Inspect the tire pressure warning reset switch (Click here).

    REPLACE TIRE PRESSURE WARNING RESET SWITCH

    (Click here)

  2. CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING RESET SWITCH - TIRE PRESSURE WARNING ECU AND RECEIVER)

    1. Disconnect the tire pressure warning reset switch H120 connector and the tire pressure warning ECU and receiver N32 connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      N32-7 (CLSW) - H120-1

      Always

      Below 1 Ω

      N32-7 (CLSW) or H120-1 - Body ground

      Always

      10 kΩ or higher

      H120-2 - Body ground

      Always

      Below 1 Ω

    REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER

    (Click here)

    REPAIR OR REPLACE HARNESS OR CONNECTOR