FRONT AXLE HUB INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH


    1. Install the front axle hub sub-assembly to the steering knuckle with the 4 new bolts.

      Torque:
      65 N*m  { 663 kgf*cm, 48 ft.*lbf }

      Note


      • Do not allow any foreign matter such as dirt or dust to enter between the steering knuckle.

      • Do not allow any foreign matter such as dirt or dust to enter between the front axle hub sub-assembly.

  2. INSPECT FRONT AXLE HUB BEARING LOOSENESS

    Click here

  3. INSPECT FRONT AXLE HUB RUNOUT

    Click here

  4. INSTALL FRONT SPEED SENSOR LH


    1. Install the bolt and speed sensor front to the steering knuckle.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

      Note

      Do not allow any foreign matter such as dirt or dust to enter between the steering knuckle and the front disc brake dust cover.

  5. INSTALL FRONT DISC

    Click here

  6. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

    Click here

  7. INSTALL FRONT WHEEL

    Torque:
    120 N*m  { 1224 kgf*cm, 89 ft.*lbf }

  8. INSPECT SPEED SENSOR SIGNAL

    Click here