KNOCK SENSOR INSTALLATION

PROCEDURE

  1. INSTALL KNOCK CONTROL SENSOR

    1. A212119C02

      *a

      Up

      Install the knock control sensor to the cylinder block sub-assembly with the bolt as shown in the illustration.

      21 N*m

      214 kgf*cm

      15 ft.*lbf

      Note:

      • If the knock control sensor has been struck or dropped, replace it.

      • Make sure that the knock control sensor is in the correct position.

      Tip:

      Perform "Inspection After Repair" after replacing the knock control sensor.

      Click here

    2. Connect the knock control sensor connector.

  2. INSTALL INTAKE MANIFOLD

    Click here