HEIGHT CONTROL SENSOR INSPECTION

PROCEDURE


  1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. Check the rear height control sensor sub-assembly LH.


      1. Connect 3 dry batteries of 1.5 V in series.

      2. Connect the positive (+) end of the batteries to terminal 3 (SHB) of the rear height control sensor sub-assembly LH and the negative (-) end of the batteries to terminal 1 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRR) and terminal 1 (SHG).

        Note


        • Do not use rechargeable batteries as they may not output a voltage of 1.5 V.

        • Do not apply a voltage of more than 6 V.

        A01HEJVC03
        *a

        Component without harness connected

        (Rear Height Control Sensor Sub-assembly LH)

        		 *b Low
        *c Standard Position *d High
        *e -45° *f 12°
        *g +45° - -

      3. Measure the voltage according to the value(s) in the table below.

        Standard Voltage
        Tester Connection Condition Specified Condition
        R1-2 (SHRR) - R1-1 (SHG) +45° (High) Approx. 4.5 V
        0° (Standard position) Approx. 2.25 V
        -45° (Low) Approx. 0.5 V

        If the result is not as specified, replace the rear height control sensor sub-assembly LH.