DIFFERENTIAL PRESSURE SENSOR(w/ GPF) ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT DIFFERENTIAL PRESSURE SENSOR


    1. B008IX8E01

      Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Data List / GPF Differential Pressure Offset Bank1.


      Powertrain > Engine > Data List
      Tester Display
      GPF Differential Pressure Offset Bank1

    5. Slide the clip and disconnect the vacuum transmitting hose assembly from the differential pressure sensor.

    6. Connect SST to the differential pressure sensor.

    7. Using SST, apply pressure to the differential pressure sensor.

      SST
      09992-00242

    8. Check the pressure value of the differential pressure sensor.

      Standard
      GTS Display Condition Specified Condition
      GPF Differential Pressure Offset Bank1 Engine switch on (IG)

      When applying 20 kPa (2.9 psi): 20 kPa (2.9 psi)

      When applying 40 kPa (5.8 psi): 40 kPa (5.8 psi)

      Note

      Perform the inspection within the range of 0 to 98 kPa (0 to 1 kg/cm2, 0 to 14.2 psi).

      If the result is not as specified, check the differential pressure sensor circuit.

    9. Disconnect SST from the differential pressure sensor.

    10. Connect the vacuum transmitting hose assembly to the differential pressure sensor and slide the clip to secure the hose.