CLUTCH RELEASE CYLINDER(for 2WW) REASSEMBLY

PROCEDURE

  1. INSTALL RELEASE CYLINDER BLEEDER PLUG

    1. Install the release cylinder bleeder plug to the release cylinder body.

      11 N*m

      112 kgf*cm

      8 ft.*lbf

    2. Install the bleeder plug cap to the release cylinder bleeder plug.

  2. INSTALL CLUTCH RELEASE CYLINDER KIT

    1. C128485

      Coat a new piston with lithium soap base glycol grease as shown in the illustration.

    2. Install the piston and a new spring to the release cylinder body.

      Note:

      Do not damage the inside of the release cylinder body.

      Tip:

      Install the maller end of the spring to the piston.

    3. Install a new boot to the push rod.

    4. Install the push rod together with the boot to the release cylinder body.