DIFFERENTIAL PRESSURE SENSOR ON-VEHICLE INSPECTION

PROCEDURE

  1. CHECK DIFFERENTIAL PRESSURE SENSOR ASSEMBLY

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Data List / DPF Differential Pressure.

      Powertrain > Engine and ECT > Data List

      Tester Display

      DPF Differential Pressure

    5. Slide the clip and disconnect the vacuum transmitting hose assembly from the differential pressure sensor assembly.

    6. A295020C01

      *a

      Pressure

      Using SST, apply pressure to the differential pressure sensor assembly.

      09992-00242

    7. Check the pressure value of the differential pressure sensor assembly.

      Standard Pressure

      Approximately the same pressure as the applied pressure is indicated.

      Note:

      Perform the inspection within the range of 0 to 98 kPa (0 to 1.0 kgf/cm2, 0 to 14.2 psi).

      If the result is not as specified, check the differential pressure sensor assembly circuit.

      Click here

    8. Connect the vacuum transmitting hose assembly to the differential pressure sensor assembly, and slide the clip to secure it.