SPEED LIMITER SYSTEM

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tip:

  • Use the following procedure to troubleshoot the cruise control system.

  • *: Use the GTS.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

    Result

    Proceed to

    NEXT
    NEXT

  2. INSPECT BATTERY VOLTAGE

    1. Measure the battery voltage with the ignition switch off.

      Standard Voltage

      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

    Result

    Proceed to

    NEXT
    NEXT

  3. CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK* (CAN)

    1. Using the GTS, check if the CAN communication system is functioning normally.

      Result

      Result

      Proceed to

      CAN DTCs are not output

      A

      CAN DTCs are output

      B
    B

    GO TO CAN COMMUNICATION SYSTEM

    Click here

    A

  4. PROBLEM SYMPTOMS TABLE

    Refer to Problem Symptoms Table.

    Click hereClick here

    Result

    Result

    Proceed to

    Fault is not listed in Problem Symptoms Table

    A

    Fault is listed in Problem Symptoms Table

    B
    B

    ADJUST, REPAIR OR REPLACEClick here

    A

  5. OVERALL ANALYSIS AND TROUBLESHOOTING*

    1. Operation Check

      Click here

    2. Terminals of ECU

      Click here

    3. Data List / Active Test

      Click here

    Result

    Proceed to

    NEXT
    NEXT

  6. ADJUST, REPAIR OR REPLACE

    Result

    Proceed to

    NEXT
    NEXT

  7. CONFIRMATION TEST

    Result

    Proceed to

    NEXT
    NEXT

    END