ELECTRIC PARKING BRAKE ACTUATOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL PARKING BRAKE ACTUATOR ASSEMBLY


    1. Apply a light coat of lithium soap base glycol grease to a new O-ring.

    2. Install the O-ring to the rear disc brake cylinder assembly.

      Note

      Make sure to replace the O-ring with a new one when installing the parking brake actuator assembly.

    3. Using a 5 mm hexagon socket wrench, install the parking brake actuator assembly to the rear disc brake cylinder assembly with the 2 bolts.

      Torque:
      for TMC Made
      8.4 N*m  { 86 kgf*cm, 74 in.*lbf }
      for TMMT Made
      11.5 N*m  { 117 kgf*cm, 8 ft.*lbf }
  2. CONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY


    1. Connect the No. 2 parking brake wire assembly connector to the parking brake actuator assembly.

  3. INSTALL REAR WHEEL

    Click here