HEIGHT CONTROL SENSOR INSPECTION

PROCEDURE


  1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. A004IRZE02
      Text in Illustration
      *a

      Component without harness connected

      (Rear Height Control Sensor Sub-assembly LH)
      *b +45°
      *c -15°
      *d -45°
      *e Reference line

      Connect 3 dry cell batteries (1.5 V) in series.

      Note

      Do not use rechargeable batteries as they may not output a voltage of 1.5 V.

    2. Connect the positive (+) lead from the batteries to terminal 3 and the negative (-) lead from the batteries to terminal 1 (GND).

    3. Measure the voltage between terminals 2 (OUT) and 1 (GND) while slowly moving the link up and down.

      Standard Voltage
      Tester Connection Condition Specified Condition
      2 (OUT) - 1 (GND) +45° (High) 4.5 V
      2 (OUT) - 1 (GND) -15° (Normal) 2.5 V
      2 (OUT) - 1 (GND) -45° (Low) 0.5 V

      If the result is not as specified, replace the rear height control sensor sub-assembly LH.