REAR DRIVE SHAFT ASSEMBLY DISASSEMBLY

CAUTION / NOTICE / HINT

Note


  • When using a vise, place aluminum plates between the part and vise.

  • When using a vise, do not overtighten it.

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. DISCONNECT REAR NO. 2 DRIVE SHAFT INBOARD JOINT BOOT CLAMP LH

    A01XNNXC01
    *a Claw Engagement

    1. Using needle-nose pliers, detach the claw engagement and disconnect the rear No. 2 drive shaft inboard joint boot clamp LH as shown in the illustration.

  2. DISCONNECT REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP LH

    Tech Tips

    Use the same procedure described for the rear No. 2 drive shaft inboard joint boot clamp LH.

  3. DISCONNECT DRIVE SHAFT INBOARD JOINT BOOT


    1. Disconnect the drive shaft inboard joint boot from the rear drive shaft inboard joint assembly LH.

  4. REMOVE REAR DRIVE SHAFT INBOARD JOINT ASSEMBLY LH


    1. Remove any old grease from the rear drive shaft inboard joint assembly LH.

    2. A01XPK1C01
      *a Matchmark

      Put matchmarks on the rear drive shaft inboard joint assembly LH and rear drive outboard joint shaft assembly LH.

      Note

      Do not use a punch to make the matchmarks.

    3. Remove the rear drive shaft inboard joint assembly LH from the rear drive outboard joint shaft assembly LH.

    4. A01XOUD

      Using a snap ring expander, remove the shaft snap ring.

    5. A01XMYSC03
      *a Matchmark

      Put matchmarks on the rear drive outboard joint shaft assembly LH and tripod joint.

      Note

      Do not use a punch to make the matchmarks.

    6. Using a brass bar and hammer, remove the tripod joint from the rear drive outboard joint shaft assembly LH.

      Note


      • Do not tap the rollers.

      • Do not drop the tripod joint

    7. Remove the rear No. 2 drive shaft inboard joint boot clamp LH, drive shaft inboard joint boot and rear drive shaft inboard joint boot clamp LH.

  5. DISCONNECT REAR NO. 2 DRIVE SHAFT OUTBOARD JOINT BOOT CLAMP LH

    A01HHD9

    1. Using a screwdriver, disconnect the rear No. 2 drive shaft outboard joint boot clamp LH as shown in the illustration.

  6. DISCONNECT REAR DRIVE SHAFT OUTBOARD JOINT BOOT CLAMP LH

    A01HDUK

    1. Using pliers, grasp the rear drive shaft outboard joint boot clamp LH and move the rear drive shaft outboard joint boot clamp LH as shown in the illustration to disconnect the rear drive shaft outboard joint boot clamp LH from the drive shaft outboard joint boot.

  7. REMOVE DRIVE SHAFT OUTBOARD JOINT BOOT


    1. Remove the rear drive shaft outboard joint boot clamp LH, drive shaft outboard joint boot and rear No. 2 drive shaft outboard joint boot clamp LH from the rear drive outboard joint shaft assembly LH.

    2. Remove any old grease from the rear drive outboard joint shaft assembly LH.

  8. REMOVE REAR DRIVE SHAFT DUST COVER LH

    A01XNB8N02

    1. Using SST and a press, remove the rear drive shaft dust cover LH.

      SST
      09950-00020

      Note

      Do not drop the rear drive shaft inboard joint assembly LH.