IMMOBILISER SYSTEM(w/o Entry and Start System)
| DTC Code | DTC Name |
|---|---|
| HOW TO PROCEED WITH TROUBLESHOOTING |
CAUTION / NOTICE / HINT
Use this procedure to troubleshoot the immobiliser system.
*: Use the GTS.
PROCEDURE
VEHICLE BROUGHT TO WORKSHOP
Result
Proceed to
NEXT
CUSTOMER PROBLEM ANALYSIS
Tip:In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
The following 5 items are important points for problem analysis:
What
Vehicle model, system name
When
Date, time, occurrence frequency
Where
Whether the problem occurs at a specific location.
Under what conditions?
Whether the doors were locked or unlocked, whether the ignition switch was ON, whether the engine was running.
How did it happen?
Problem symptoms
Result
Proceed to
NEXT
INSPECT BATTERY VOLTAGE
Measure the battery voltage.
Standard voltage
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
Result
Proceed to
NEXT
CRANK ENGINE FOR MORE THAN 10 SECONDS
Result
Proceed to
NEXT
CHECK FOR DTC* (ECM AND TELEPHONE TRANSCEIVER ASSEMBLY)
Check for DTCs and note any codes that are output.
Powertrain > Engine and ECT > Trouble Codes
Powertrain > Engine > Trouble Codes
Body Electrical > Telematics > Trouble Codes
Body Electrical > Immobiliser > Trouble Codes
Tip:Before checking for DTCs, perform the "DTC Output Confirmation Operation" of each diagnostic procedure.
Result
Proceed to
DTCs are not output
SFI system DTCs are output (for 2AR-FE)
SFI system DTCs are output (for 3ZR-FAE)
SFI system DTCs are output (for 3ZR-FE)
ECD system DTCs are output (for 1AD-FTV)
ECD system DTCs are output (for 2AD-CCo)
ECD system DTCs are output (for 2AD-DPF)
ECD system DTCs are output (for 2AD-FHV)
Blocking system DTCs are output (w/ Blocking System)
Immobiliser system DTCs are output
CHECK FOR DTC* (TRANSPONDER KEY ECU ASSEMBLY)
Check for DTCs and note any codes that are output.
Body Electrical > Immobiliser > Trouble Codes
Tip:Before checking for DTCs, perform the "DTC Output Confirmation Operation" of each diagnostic procedure.
Result
Proceed to
DTCs are not output
Immobiliser system DTCs are output
PROBLEM SYMPTOMS TABLE
Refer to Problem Symptoms Table.
Result
Proceed to
Fault is not listed in problem symptoms table
Fault is listed in problem symptoms table
Fault is listed in problem symptoms table ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE
OVERALL ANALYSIS AND TROUBLESHOOTING*
Data List / Active Test
Terminals of ECU
Result
Proceed to
NEXT
REPAIR OR REPLACE
Tip:If the transponder key ECU assembly, ECM, or key is replaced, refer to the Service Bulletin.
Result
Proceed to
NEXT
CHECK FOR DTC*
Clear the DTCs.
Body Electrical > Immobiliser > Clear DTCs
Check for DTCs.
Body Electrical > Immobiliser > Trouble Codes
Tip:Before checking for DTCs, perform the "DTC Output Confirmation Operation" of each diagnostic procedure.
Result
Proceed to
DTCs are not output
Immobiliser system DTCs are output
DTCs are not output END