TIRE PRESSURE WARNING RECEIVER(for Wagon) INSTALLATION

PROCEDURE

1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER

   Note:

   • Do not drop the tire pressure warning ECU and receiver, strike it with tools or subject it to impact.

   • If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.

   1. 

      *A	for Type A
      *B	for Type B

      Connect the connector to the tire pressure warning ECU and receiver.

   2. Engage the 2 hooks to temporarily install the tire pressure warning ECU and receiver.

   3. Install the bolt.

      for Type A

      8.3 N*m

      85 kgf*cm

      73 in.*lbf

      for Type B

      10 N*m

      102 kgf*cm

      7 ft.*lbf

      Note:

      There are 2 types of bolts and the tightening torque depends on the type of bolt used as shown in the illustration. Therefore, confirm the tightening torque before installing the bolt.

2. INSTALL ROOF HEADLINING

   Click hereClick here

3. REGISTER TRANSMITTER ID

   Click here

4. INSPECT TIRE PRESSURE WARNING SYSTEM

   Click here

5. PERFORM INITIALIZATION

   Click here