REAR DOOR LOCK REMOVAL

CAUTION / NOTICE / HINT

Tip:
  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. PRECAUTION

    CAUTION:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices befor eproceeding with work.

    Click hereClick hereClick hereClick hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick hereClick here

  3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

  4. REMOVE DOOR ASSIST GRIP COVER LH

  5. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

  6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

  7. REMOVE REAR DOOR SERVICE HOLE COVER LH

  8. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

  9. REMOVE REAR DOOR QUARTER WINDOW GLASS LH

  10. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

  11. REMOVE REAR DOOR GLASS RUN LH

  12. REMOVE REAR DOOR WITH MOTOR LOCK ASSEMBLY LH

    1. B337022C01

      *A

      w/o Double Locking System

      *B

      w/ Double Locking System

      Disconnect the connector.

    2. Using a T30 "TORX" socket wrench, remove the 3 screws.

    3. B337023C01

      *a

      Downward

      Move the rear door with motor lock assembly LH downward and pull the release plate out of the rear door outside handle frame.

    4. Remove the rear door with motor lock assembly LH and cables as a unit.

    5. B337024

      Remove the door lock wiring harness seal from the rear door with motor lock assembly LH.

  13. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

  14. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH