DRIVE SHAFT / PROPELLER SHAFT SERVICE DATA

Front Drive Shaft Assembly
Standard drive shaft length for LH side 536.6 mm (1.76 ft.)
for RH side 950.1 mm (3.11 ft.)
Standard drive shaft boot clamp clearance Front axle outboard joint boot clamp 1.2 to 4.0 mm (0.0473 to 0.1574 in.)
Front No. 2 axle outboard joint boot clamp -
Front axle inboard joint boot clamp
Front No. 2 axle inboard joint boot clamp
Standard grease capacity Front axle inboard joint boot 205.0 to 225.0 g (7.23 to 7.93 oz)
Front axle outboard joint boot 175.0 to 195.0 g (6.18 to 6.87 oz)
Rear Drive Shaft Assembly
Standard drive shaft length LH Side 2WD 708.0 mm (2.322 ft.)
AWD 707.9 mm (2.321 ft.)
RH Side 2WD 754.0 mm (2.473 ft.)
AWD 752.9 mm (2.469 ft.)
Propeller Shaft Assembly
Propeller shaft assembly (front side) runout for 8GR-FKS Maximum runout: 0.6 mm (0.0236 in.)
for V35A-FTS 2WD Maximum runout: 0.6 mm (0.0236 in.)
AWD Maximum runout: 0.4 mm (0.0157 in.)
Propeller shaft assembly (rear side) runout Maximum runout: 0.6 mm (0.0236 in.)
Propeller with center bearing shaft assembly Distance between the surface of the No. 1 center support bearing assembly and the surface of the cushion 10.5 to 12.5 mm (0.414 to 0.492 in.)
Joint Angle No. 2 Joint Angle for 2WD 8GR-FKS 0°05' +/- 30' (0.08° +/- 0.50°)
V35A-FTS 0°04' +/- 30' (0.07° +/- 0.50°)
for AWD 1°10' +/- 30' (1.17° +/- 0.50°)
No. 3 Joint Angle for 2WD 8GR-FKS 1°00' +/- 32' (1.00° +/- 0.53°)
V35A-FTS 1°00' +/- 32' (1.00° +/- 0.53°)
for AWD 1°13' +/- 32' (1.22° +/- 0.53°)
Adjusting Washer Thickness 9.0 mm (0.354 in.)
11.0 mm (0.433 in.)
13.5 mm (0.531 in.)