FRONT DIFFERENTIAL OIL SEAL REPLACEMENT

PROCEDURE

  1. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  2. REMOVE REAR ENGINE UNDER COVER RH

    Click hereClick hereClick here

  3. REMOVE REAR ENGINE UNDER COVER LH

    Click hereClick hereClick here

  4. DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID

    1. C242832

      Using a 6 mm socket hexagon wrench, remove the overflow plug and gasket from the continuously variable transaxle assembly.

    2. C279062C06

      *1

      No. 1 Transmission Oil Filler Tube

      Using a 6 mm socket hexagon wrench, remove the No. 1 transmission oil filler tube from the continuously variable transaxle assembly and drain the continuously variable transaxle fluid.

    3. Using a 6 mm socket hexagon wrench, install the No. 1 transmission oil filler tube to the continuously variable transaxle assembly.

      1.7 N*m

      17 kgf*cm

      15 in.*lbf

    4. Temporarily install the gasket and overflow plug.

      Tip:

      Reuse the old gasket. The plug will be removed again to adjust the fluid level.

  5. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH AND RH

    Click hereClick hereClick here

  6. REMOVE DRIVE SHAFT BEARING BRACKET

    Click hereClick hereClick here

  7. REMOVE CVT TYPE T OIL SEAL LH

    C103977E02

    1. Using SST, remove the CVT type T oil seal LH from the transaxle case.

      09308-00010

      Note:

      Do not damage the transaxle case.

  8. REMOVE CVT TYPE T OIL SEAL RH

    C100696E02

    1. Using SST, remove the CVT type T oil seal RH from the transaxle housing.

      09308-00010

      Note:

      Do not damage the transaxle housing.

  9. INSTALL CVT TYPE T OIL SEAL LH

    C194180E02

    1. Using SST and a hammer, tap in a new CVT type T oil seal LH to the transaxle case.

      Standard depth

      -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

      Note:

      Do not damage the lip of the CVT type T oil seal LH.

      09316-10010

      09950-70010

      09951-07200

    2. Coat the lip of the CVT type T oil seal LH with MP grease.

  10. INSTALL CVT TYPE T OIL SEAL RH

    C281505E01

    1. Using SST and a hammer, tap in a new CVT type T oil seal RH to the transaxle housing.

      Standard depth

      -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

      Note:

      Do not damage the lip of the CVT type T oil seal RH.

      09950-70010

      09951-07200

      09951-00480

      09951-00610

      09952-06010

      09631-12090

    2. Coat the lip of the CVT type T oil seal RH with MP grease.

  11. INSTALL DRIVE SHAFT BEARING BRACKET

    Click hereClick here

  12. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH AND RH

    Click hereClick hereClick hereClick here

  13. ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID

    Click hereClick hereClick here

  14. INSTALL REAR ENGINE UNDER COVER RH

    Click hereClick here

  15. INSTALL REAR ENGINE UNDER COVER LH

    Click hereClick here

  16. INSTALL NO. 1 ENGINE UNDER COVER

    Click here