OIL PRESSURE SENSOR INSTALLATION

PROCEDURE

  1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

    A297058C01

    *a

    Adhesive

    1. Apply adhesive to 2 or 3 threads of the oil pressure sender gauge assembly.

      Adhesive

      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    2. A297056C02

      *a

      27 mm Deep Socket Wrench

      Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly.

      15 N*m

      153 kgf*cm

      11 ft.*lbf

      Note:

      Do not start the engine for at least 1 hour after installation.

    3. Connect the oil pressure sender gauge assembly connector.

  2. INSPECT FOR OIL LEAK

    Click hereClick hereClick here

  3. INSTALL REAR ENGINE UNDER COVER RH

  4. INSTALL NO. 1 ENGINE UNDER COVER