OIL FILTER INSTALLATION


  1. INSTALL OIL FILTER SUB-ASSEMBLY (for Type A)


    1. B007PE2E01

      Check and clean the oil filter installation surface.

    2. Apply clean engine oil to the gasket of a new oil filter sub-assembly.

    3. Lightly screw the oil filter sub-assembly into place, and tighten it until the gasket contacts the seat.

    4. B007ULXE02

      Using SST, tighten the oil filter sub-assembly.

      SST
      09228-07501
      When using a torque wrench
      Tighten the oil filter sub-assembly.
      Torque:
      17 N*m  { 175 kgf*cm, 13 ft.*lbf }
      When not using a torque wrench
      Tighten the oil filter sub-assembly an additional 3/4 turn.

  2. INSTALL OIL FILTER ELEMENT (for Type B)


    1. Clean the inside of the oil filter cap, its threads and its O-ring groove.

    2. B007SY3E01
      Text in Illustration
      *1 O-Ring (for Cap)
      *a CORRECT
      *b INCORRECT

      Apply a small amount of engine oil to a new O-ring (for cap) and install it to the oil filter cap.

      Note


      • Be sure to install the O-ring (for cap) in the proper location, otherwise oil may leak.

      • Do not twist the O-ring (for cap).

    3. Set a new oil filter element in the oil filter cap.

    4. Remove any dirt or foreign matter from the installation surface of the engine.

    5. Apply a small amount of engine oil to the O-ring (for cap) again and temporarily install the oil filter cap.

    6. B007T3OE01
      Text in Illustration
      *1 Oil Filter Cap
      *2 O-Ring (for Cap)
      *3 Oil Filter Bracket
      *a No Gap

      Using SST, tighten the oil filter cap.

      SST
      09228-06501
      Torque:
      25 N*m  { 255 kgf*cm, 18 ft.*lbf }

  3. ADD ENGINE OIL


    1. Add fresh engine oil.

      Standard Capacity
      Item Specified Condition
      Drain and refill without oil filter change 4.9 liters (5.2 US qts, 4.3 Imp. qts)
      Drain and refill with oil filter change 5.3 liters (5.6 US qts, 4.7 Imp. qts)
      Dry fill 6.7 liters (7.1 US qts, 5.9 Imp. qts)

    2. Install the oil filler cap.

  4. INSPECT FOR OIL LEAK


    1. Start the engine. Make sure that there are no oil leaks from the areas that were worked on.

  5. INSTALL ENGINE UNDER COVER NO. 2 (for Narrow Body, w/ Engine Under Cover No. 2)

    Torque:
    13 N*m  { 133 kgf*cm, 10 ft.*lbf }

  6. INSTALL ENGINE SIDE UNDER COVER RH (for Wide Body, w/ Engine Side Under Cover RH)

    Torque:
    13 N*m  { 133 kgf*cm, 10 ft.*lbf }