FRONT DOOR BELT MOULDING REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  4. REMOVE FRONT ARMREST ASSEMBLY LH

    Click here

  5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

    Click here

  6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  7. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  8. REMOVE FRONT DOOR SERVICE HOLE COVER LH

    Click here

  9. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

    Click here

  10. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  11. REMOVE FRONT DOOR GLASS RUN LH

    Click here

  12. REMOVE FRONT DOOR BELT MOULDING LH

    B236327C01

    *1

    Protective Tape

    1. Put protective tape around the belt moulding.

    2. Detach the 6 claws and remove the front door belt moulding.