TRANSMISSION CONTROL CABLE INSTALLATION

INSTALL TRANSAXLE CONTROL CABLE ASSEMBLY

Install the transaxle control cable assembly with the 2 bolts.

5.0 N*m

51 kgf*cm

44 in.*lbf
Connect the transaxle control cable assembly to the control cable bracket, and install 2 new clips.
Connect the transaxle control cable assembly to the manual transaxle assembly, and install the 2 clips.

CONNECT ENGINE WIRE

Connect the engine wire with bolt and clamp.

7.7 N*m

79 kgf*cm

68 in.*lbf

INSTALL AIR CLEANER BRACKET

for 1AD-FTV:

w/ Stop And Start System (Click here)

w/o Stop And Start System (Click here)

for 2AD-FTV:

Click here

INSTALL FRONT FLOOR COVER

Click here

CONNECT TRANSAXLE CONTROL CABLE ASSEMBLY

Turn the lock nut of the transaxle control cable assembly 180° clockwise. While holding the lock nut in place, push in the stopper to lock the lock nut.

*1	Cable Lock	*2	Lock Nut
*a	Push in	-	-

Note:

Do not over-rotate the nut as it will come off the internal spring and the transaxle control cable assembly will not be reusable.

Tip:

If the stopper cannot be pushed in, slightly turn the nut counterclockwise and then push in the cable lock again.

Connect the outer part of the transaxle control cable assembly to the floor shift shift lever assembly. Check that the stopper returns to the pulled-out position.

*1	Cable Lock	*2	Lock Nut
*3	Floor Shift Shift Lever Assembly	-	-

*1	Slider
*2	Lock Piece

Slide the slider in the direction shown in the illustration and pull out the lock piece.

*1	Select Control Cable
*2	Shift Control Cable

Connect the shift control cable to the floor shift shift lever assembly.

Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.
Push the lock piece into the adjuster case and lock it.

Note:
Make sure that the lock piece is completely locked by the slider.
Install a new clip to the select control cable.

Tip:
Install a new clip.

INSTALL REAR CONSOLE BOX SUB-ASSEMBLY

Click here