STEERING WHEEL INSTALLATION

PROCEDURE

  1. ADJUST SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

  2. INSTALL STEERING WHEEL ASSEMBLY

    1. Align the matchmarks on the steering wheel assembly and steering main shaft assembly.

    2. Install the steering wheel assembly set nut.

      50 N*m

      510 kgf*cm

      37 ft.*lbf

  3. INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY

  4. INSTALL CRUISE CONTROL MAIN SWITCH

  5. INSTALL STEERING PAD SWITCH ASSEMBLY

    1. Attach the 2 claws to install the steering pad switch assembly.

    2. Install the 4 screws.

    3. Connect the connector.

  6. INSTALL STEERING PAD

  7. INSTALL NO. 2 STEERING WHEEL LOWER COVER

  8. INSTALL NO. 3 STEERING WHEEL LOWER COVER

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  10. INSPECT SRS WARNING LIGHT

    1. Inspect the SRS warning light (Click hereClick here).