CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM Pattern Select Switch Sport Mode Circuit

DTC Code DTC Name
Pattern Select Switch Sport Mode Circuit

DESCRIPTION

The ECM memory contains the programs for the normal and sport shift patterns.

By following the programs corresponding to the signals from the combination switch, the park/neutral position switch and other various sensors, the ECM switches the shift control solenoid valves on and off, and controls the transaxle gear ratio.

WIRING DIAGRAM

C278992E02

CAUTION / NOTICE / HINT

Note:

  • Perform initialization when parts related to the continuously variable transaxle are replaced.

    Click here

  • Check that no DTCs are stored after performing initialization.

    Click here

PROCEDURE

  1. INSPECT COMBINATION SWITCH ASSEMBLY

    1. C277027C02

      *1

      Combination Switch Assembly

      Remove the combination switch.

      Click here

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Switch Condition

      Specified Condition

      2 (MSW1) - 4 (MSW2)

      Combination switch (SPORT) on

      Below 1 Ω

      2 (MSW1) - 4 (MSW2)

      Combination switch (SPORT) off

      10 kΩ or higher

    Result

    Proceed to

    OK

    NG
    NG

    REPLACE COMBINATION SWITCH ASSEMBLY

    Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (COMBINATION SWITCH - BODY GROUND)

    1. C277026C02

      *a

      Front view of wire harness connector

      (to Combination Switch Assembly)

      Disconnect the combination switch connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      G60-4 (MSW2) - Body ground

      Always

      Below 1 Ω

    Result

    Proceed to

    OK

    NG
    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK HARNESS AND CONNECTOR (COMBINATION SWITCH - ECM)

    1. C277060C01

      *a

      Front view of wire harness connector

      (to ECM)

      Disconnect the ECM connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Switch Condition

      Specified Condition

      A62-57 (PWMS) - Body ground

      Combination switch (SPORT) on

      Below 1 Ω

      A62-57 (PWMS) - Body ground

      Combination switch (SPORT) off

      10 kΩ or higher

    Result

    Proceed to

    OK

    NG
    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. REPLACE ECM

    1. Replace the ECM.

    Result

    Proceed to

    NEXT
    NEXT

    PERFORM INITIALIZATION

    Click here