FRONT DOOR LOCK(for Hatchback, Wagon) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click hereClick hereClick hereClick here

2. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY

   Click hereClick here

3. INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

   Click hereClick here

4. INSTALL FRONT DOOR LOCK ASSEMBLY

   Note:

   • When reusing the removed front door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

   • Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.

   • Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water ingress. This may result in a malfunction of the front door lock assembly.

   1. Apply MP grease to the sliding parts of the front door lock assembly.

   2. When reusing the front door lock assembly:

      1. 

         Install a new door lock wiring harness seal to the front door lock assembly.

   3. 

      *1	Front Door Lock Open Rod

      Connect the front door lock open rod to the front door lock assembly.

      Tip:

      Make sure that the front door lock open rod is securely connected to the front door lock assembly.

   4. Using a T30 "TORX" socket wrench, install the front door lock assembly with the 3 screws.

      5.0 N*m

      51 kgf*cm

      44 in.*lbf

   5. Connect the connector.

5. INSTALL FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side)

   Click hereClick here

6. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

   Click hereClick here

7. INSTALL FRONT DOOR GLASS RUN

   Click hereClick here

8. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

   Click hereClick here

9. INSTALL FRONT DOOR SERVICE HOLE COVER

   Click hereClick here

10. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click hereClick here

11. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

    Click hereClick here

12. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click hereClick here

13. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click hereClick here

14. INSTALL DOOR ASSIST GRIP ASSEMBLY

    Click hereClick here

15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

16. INITIALIZE POWER WINDOW CONTROL SYSTEM

    • for Models with Jam Protection Function on 4 Windows:Click here

    • for Models with Jam Protection Function on Driver Door Window Only:Click here

17. INSPECT POWER WINDOW OPERATION

    • for Models with Jam Protection Function on 4 Windows:Click here

    • for Models with Jam Protection Function on Driver Door Window Only:Click hereClick here