STEERING PAD SWITCH REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS. Read the precautionary notices concerning the SRS before servicing.

w/ Occupant Classification System:Click here

w/o Occupant Classification System:Click here

Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click hereClick here).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereClick here).

  3. REMOVE STEERING PAD

    for Single Type:Click here

    for Dual Type:Click here

  4. REMOVE STEERING PAD SWITCH ASSEMBLY

    1. C348611

      Disconnect the connector from the spiral cable.

      Tip:

      If the vehicle is equipped with a cruise control switch and shift paddle switch, disconnect their connectors and connector clamps.

    2. C348612

      Remove the 2 screws.

    3. Detach the 2 pins and 6 claws and remove the switch assembly.