FRONT DOOR LOCK(for Hatchback, Wagon) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click hereClick hereClick hereClick here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE DOOR ASSIST GRIP ASSEMBLY

   Click hereClick here

4. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

   Click hereClick here

5. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

   Click hereClick here

6. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

   Click hereClick here

7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

   Click hereClick here

8. REMOVE FRONT DOOR SERVICE HOLE COVER

   Click hereClick here

9. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

   Click hereClick here

10. REMOVE FRONT DOOR GLASS RUN

    Click hereClick here

11. REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

    Click hereClick here

12. REMOVE FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side)

    Click hereClick here

13. REMOVE FRONT DOOR LOCK ASSEMBLY

    1. 

       *1	Front Door Lock Open Rod

       Disconnect the connector.

    2. Using a T30 "TORX" socket wrench, remove the 3 screws.

    3. Slide the front door lock assembly downward, and remove the front door lock assembly and cables as a unit.

    4. When reusing the front door lock assembly:

       1. 

          Remove the door lock wiring harness seal from the front door lock assembly.

14. REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

    Click hereClick here

15. REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY

    Click hereClick here