TIRE PRESSURE WARNING SYSTEM, Diagnostic DTC:C2171/71

DTC Code DTC Name
C2171/71 Transmitter ID not Registered

DESCRIPTION

The IDs of each tire pressure warning valve and transmitter are registered to the tire pressure warning ECU and receiver.

When the ECU detects that a transmitter ID code is not registered in the ECU, this DTC is stored.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Note

C2171/71

Transmitter ID not Registered

Transmitter ID code is not registered. (When an ID code is unregistered for 3 minutes or more)

Tire pressure warning ECU and receiver

-

CAUTION / NOTICE / HINT

Note:
  • When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

  • It is necessary to perform initializationClick hereafter registrationClick hereof the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.

PROCEDURE

  1. CONFIRM REGISTRATION CONDITION (REGISTERED ID CODES)

    1. Turn the ignition switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the ignition switch to ON.

    4. Turn the GTS on.

    5. Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

    6. Check the values by referring to the table below.

      Chassis > Tire Pressure Monitor > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      Registered ID 1 Code

      Registered ID1 code

      min.: 0

      max.: FFFFFFF*1

      ID No. registered for transmitter ID1 displayed

      -

      Registered ID 2 Code

      Registered ID2 code

      min.: 0

      max.: FFFFFFF*1

      ID No. registered for transmitter ID2 displayed

      -

      Registered ID 3 Code

      Registered ID3 code

      min.: 0

      max.: FFFFFFF*1

      ID No. registered for transmitter ID3 displayed

      -

      Registered ID 4 Code

      Registered ID4 code

      min.: 0

      max.: FFFFFFF*1

      ID No. registered for transmitter ID4 displayed

      -

      Registered ID 5 Code

      Registered ID5 code

      min.: 0

      max.: FFFFFFF*1

      ID No. registered for transmitter ID5 displayed

      *2

      Chassis > Tire Pressure Monitor > Data List

      Tester Display

      Registered ID 1 Code

      Registered ID 2 Code

      Registered ID 3 Code

      Registered ID 4 Code

      Registered ID 5 Code

      Tip:
      • *1: Displayed only when the ID No. is not registered.

      • *2: w/ Full Size Spare Tire

      OK

      The registered transmitter ID codes are displayed on the GTS.

    Result

    Proceed to

    OK

    NG

    OK

    REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER

    NG
  2. PERFORM REGISTRATION (TRANSMITTER ID)

    1. Perform registration.

      Click here

    Result

    Proceed to

    NEXT

    NEXT
  3. PERFORM INITIALIZATION

    1. Perform initialization.

      Click here

    Result

    Proceed to

    NEXT

    NEXT
  4. CONFIRM TIRE INFLATION PRESSURE (DATA LIST)

    1. Turn the ignition switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the ignition switch to ON.

    4. Turn the GTS on.

    5. Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

    6. Check the values by referring to the table below.

      Chassis > Tire Pressure Monitor > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      ID 1 Tire Inflation Pressure

      ID1 tire inflation pressure

      min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)

      max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)

      Actual tire inflation pressure

      If N/A is displayed, data has not been received.*1

      ID 2 Tire Inflation Pressure

      ID2 tire inflation pressure

      min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)

      max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)

      Actual tire inflation pressure

      If N/A is displayed, data has not been received.*1

      ID 3 Tire Inflation Pressure

      ID3 tire inflation pressure

      min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge)/ 0 kPa (0 kgf/cm2, 0 psi)

      max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)

      Actual tire inflation pressure

      If N/A is displayed, data has not been received.*1

      ID 4 Tire Inflation Pressure

      ID4 tire inflation pressure

      min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)

      max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)

      Actual tire inflation pressure

      If N/A is displayed, data has not been received.*1

      ID 5 Tire Inflation Pressure

      ID5 tire inflation pressure

      min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)

      max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)

      Actual tire inflation pressure

      • If N/A is displayed, data has not been received.*1

      • *2

      Chassis > Tire Pressure Monitor > Data List

      Tester Display

      ID 1 Tire Inflation Pressure

      ID 2 Tire Inflation Pressure

      ID 3 Tire Inflation Pressure

      ID 4 Tire Inflation Pressure

      ID 5 Tire Inflation Pressure

      Tip:
      • *1: It may take a few minutes until the values are displayed.

      • *2: w/ Full Size Spare Tire

      • When an "ID Tire Inflation Pressure" value has not changed, reset the tire pressure to the appropriate specified value and rotate the tire 90 to 270 degrees. Then rapidly release the tire pressure and recheck the value.

    Result

    Result

    Proceed to

    All tire pressure readings are equal to specified values.

    A

    Tire pressure values are not displayed.

    B

    A

    END

    B

    REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER