ECD SYSTEM(for Swirl Control Valve), Diagnostic DTC:P1478

DTC Code DTC Name
P1478 Swirl Valve Under Voltage Error

DESCRIPTION

Refer to DTC P2016 (Click here).

DTC No.

DTC Detection Condition

Trouble Area

P1478

Swirl control valve actuator output voltage is low voltage for 0.2 seconds.

(3 trip detection logic)

  • Open or short in swirl control valve circuit

  • ECM
Table 1. Related Data List

DTC No.

Data List

P1478

Swirl Valve Actuator Position

WIRING DIAGRAM

Refer to DTC P2016 (Click here).

CAUTION / NOTICE / HINT

Note:

When replacing the ECM, the ECM needs Registration and Initialization (Click here).

Tip:

  • When the ECM must be replaced, before replacing the ECM, perform the "Learning Values Save" function using the GTS. Then after installing the new ECM, perform all of the initialization/registrations for the "Learning Values Write" function by following the instructions shown on the GTS display.

  • Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR (SWIRL CONTROL VALVE - ECM)

    1. Disconnect the swirl control valve connector.

    2. Disconnect the ECM connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      C117-3 (SCV+) - C112-49 (IA1+)

      Always

      Below 1 Ω

      C117-4 (SCV-) - C112-19 (IA1-)

      Always

      Below 1 Ω

      C117-3 (SCV+) or C112-49 (IA1+) - Body ground

      Always

      10 kΩ or higher

      C117-4 (SCV-) or C112-19 (IA1-) - Body ground

      Always

      10 kΩ or higher

    REPAIR OR REPLACE HARNESS OR CONNECTORClick here

  2. REPLACE ECM

    1. Replace the ECM (Click here).

    CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIREDClick here

  3. REPAIR OR REPLACE HARNESS OR CONNECTOR

    1. Repair or replace the harness or connector.

  4. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Clear the DTCs (Click here).

    4. Turn the ignition switch off and wait for 60 seconds or more [A].

    5. Perform road test [B].

    6. Repeat [A] and [B] for the number of trips detected.

    7. Enter the following menus: Engine and ECT / Trouble Codes.

    8. Confirm that the DTC is not output again.

    END