| DTC Code | DTC Name |
|---|---|
| B2417 | Headlight Beam Level Control Motor LH Malfunction |
| B2418 | Headlight Beam Level Control Motor RH Malfunction |
DESCRIPTION
The headlight leveling motor receives a signal from the headlight ECU sub-assembly to operate. The headlight ECU sub-assembly receives a signal indicating the operating conditions of the headlight leveling motor. If either headlight leveling motor malfunctions, the headlight ECU sub-assembly LH stores DTC B2417 or B2418.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2417 | Headlight Beam Level Control Motor LH Malfunction |
|
|
for Triple Beam Headlight |
| B2418 | Headlight Beam Level Control Motor RH Malfunction |
|
|
for Triple Beam Headlight |
WIRING DIAGRAM
| *a | Headlight Leveling Motor |
| *b | Headlight Unit |
| *c | Headlight ECU Sub-assembly |
CAUTION / NOTICE / HINT
Note
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
PROCEDURE
CLEAR DTC
Clear the DTCs.
| Result | ||
|---|---|---|
|
| NEXT |
|
CHECK FOR DTC
Turn the engine switch on (IG).
Check for DTCs.
| OK |
|---|
| DTC B2417 and B2418 are not output. |
| Result | ||||||||
|---|---|---|---|---|---|---|---|---|
|
| A |
|
USE SIMULATION METHOD TO CHECK Click here |
| C |
|
PERFORM ACTIVE TEST USING GTS Click here |
| B |
|
PERFORM ACTIVE TEST USING GTS
Connect the GTS to the DLC3.
Start the engine.
Turn the GTS on.
Enter the following menus: Body Electrical / AFS / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Drive The Leveling Motor | Headlight leveling motor upward or downward operation | Stop/Down/Up | Perform the Active Test with the engine started and vehicle stopped |
| Tester Display |
|---|
| Drive The Leveling Motor |
| OK |
|---|
| Headlight leveling motor LH operates normally. |
| Result | |||
|---|---|---|---|
|
| OK |
|
REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH Click here |
| NG |
|
INSPECT HEADLIGHT UNIT LH
Remove the headlight assembly LH.
Remove the headlight unit assembly LH from the headlight assembly LH.
| *a | Component without harness connected (to Headlight Leveling Motor LH) |
| *b | Component without harness connected (to Headlight ECU Sub-assembly LH) |
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||
|---|---|---|---|---|---|---|---|---|---|
|
| Result | |||
|---|---|---|---|
|
| NG |
|
REPLACE HEADLIGHT UNIT LH Click here |
| OK |
|
REPLACE HEADLIGHT LEVELING MOTOR LH
Replace the headlight leveling motor LH with a new or known good one.
| Result | ||
|---|---|---|
|
| NEXT |
|
CLEAR DTC
Clear the DTCs.
| Result | ||
|---|---|---|
|
| NEXT |
|
CHECK FOR DTC
Turn the engine switch on (IG).
Check for DTCs.
| OK |
|---|
| DTC B2417 is not output. |
| Result | |||
|---|---|---|---|
|
| OK |
|
END (HEADLIGHT LEVELING MOTOR LH WAS DEFECTIVE) |
| NG |
|
REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH Click here |
PERFORM ACTIVE TEST USING GTS
Connect the GTS to the DLC3.
Start the engine.
Turn the GTS on.
Enter the following menus: Body Electrical / AFS / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Drive The Leveling Motor | Headlight leveling motor upward or downward operation | Stop/Down/Up | Perform the Active Test with the engine started and vehicle stopped |
| Tester Display |
|---|
| Drive The Leveling Motor |
| OK |
|---|
| Headlight leveling motor RH operates normally. |
| Result | |||
|---|---|---|---|
|
| OK |
|
REPLACE HEADLIGHT ECU SUB-ASSEMBLY RH Click here |
| NG |
|
INSPECT HEADLIGHT UNIT RH
Remove the headlight assembly RH.
Remove the headlight unit assembly RH from the headlight assembly RH.
| *a | Component without harness connected (to Headlight Leveling Motor RH) |
| *b | Component without harness connected (to Headlight ECU Sub-assembly RH) |
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||
|---|---|---|---|---|---|---|---|---|---|
|
| Result | |||
|---|---|---|---|
|
| NG |
|
REPLACE HEADLIGHT UNIT RH Click here |
| OK |
|
REPLACE HEADLIGHT LEVELING MOTOR RH
Replace the headlight leveling motor RH with a new or known good one.
| Result | ||
|---|---|---|
|
| NEXT |
|
CLEAR DTC
Clear the DTCs.
| Result | ||
|---|---|---|
|
| NEXT |
|
CHECK FOR DTC
Turn the engine switch on (IG).
Check for DTCs.
| OK |
|---|
| DTC B2418 is not output. |
| Result | |||
|---|---|---|---|
|
| OK |
|
END (HEADLIGHT LEVELING MOTOR RH WAS DEFECTIVE) |
| NG |
|
REPLACE HEADLIGHT ECU SUB-ASSEMBLY RH Click here |