DYNAMIC TORQUE CONTROL AWD SYSTEM DIAGNOSIS SYSTEM


  1. DESCRIPTION

    Dynamic torque control AWD system data and Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the GTS to check for malfunctions and perform repairs.

  2. CHECK DATA LINK CONNECTOR 3 (DLC3)


    1. Check the DLC3.

      Click here

  3. FUNCTION OF AWD WARNING


    1. The AWD warning message displayed on the multi-information display warns the driver if the condition of dynamic torque control AWD system is poor or abnormal.

    2. If the 4WD ECU assembly detects a malfunction, the master warning light illuminates and the multi-information display displays warning messages to warn the driver in accordance with malfunction.

      Tech Tips

      Check that the master warning light illuminates for approximately 4 seconds.

  4. CHECK MASTER WARNING LIGHT


    1. Turn the engine switch on (IG), and check that the master warning light comes on for approximately 4 seconds.

      Tech Tips

      The master warning light goes off while the system is in DTC output mode.

  5. CHECK AWD WARNING


    1. Check AWD warning.


      1. B007ZE2C56
        *a Front view of DLC3

        Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3 (to enter diagnostic mode).

        SST
        09843-18040

      2. Turn the engine switch on (IG).

      3. Read the output of the multi-information display.

        Tech Tips


        • Although the test mode is not set for the dynamic torque control AWD system, the message is displayed on the multi-information display when the test mode is activated for checking the VSC, etc.

        • During diagnosis, "DIAG AWD" is displayed on the multi-information display.

        • If the dynamic torque control AWD system is normal, "DIAG AWD FF" is displayed on the multi-information display.

        • If a malfunction in the dynamic torque control AWD system is detected, "DIAG AWD XX (DTC)" is displayed on the multi-information display.

        • DTCs are explained in "DIAGNOSTIC TROUBLE CODE CHART".

          Click here

        • If the normal system code ("DIAG AWD FF") or stored DTCs are not displayed on the multi-information display, perform the following troubleshooting procedures.

          Trouble Area See procedure
          AWD warning light (Remains illuminated)

          Click here

          AWD warning light (Does not illuminate)

          Click here

  6. CHECK AWD LOCK MODE INDICATOR LIGHT


    1. Check AWD lock mode indicator light.


      1. When the engine switch is turned on (IG), check that the AWD lock mode indicator light illuminates and goes off within approximately 4 seconds.

        Tech Tips

        If the AWD lock mode indicator light does not illuminate, check for combination meter assembly and CAN communication system DTCs, since the 4WD ECU assembly and combination meter assembly are connected by the CAN communication line.

        If the AWD lock mode indicator light does not illuminate, perform relevant troubleshooting procedures. The relevant troubleshooting procedures are in the sections listed in the table below.

        Trouble Area See Procedure
        AWD lock indicator light (Does not illuminated)

        Click here