BLOWER UNIT DISASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE BLOWER MOTOR CONTROL (for Automatic Air Conditioning System)


    1. A01L9HY

      w/ Rear Resistor Duct:


      1. Detach the clamp.

      2. Disconnect the connector.

      3. Remove the 2 screws and blower motor control.

    2. A01WBQN

      w/o Rear Resistor Duct:

      Remove the 2 screws and blower motor control.

  2. REMOVE BLOWER RESISTOR (for Manual Air Conditioning System, Manual Cooler System)


    1. A01W8GZ

      Remove the 2 screws and blower resistor.

  3. REMOVE AIR FILTER CASE


    1. A01WAP8C01
      B0069FO Remove in this Direction (1)
      B0068NX Remove in this Direction (2)

      for Automatic Air Conditioning System:

      Detach the claw and guide and remove the air filter case.

    2. A01WB9KC01
      B0069FO Remove in this Direction (1)
      B0068NX Remove in this Direction (2)

      for Manual Air Conditioning System, Manual Cooler System:

      Detach the claw and guide and remove the air filter case.

  4. REMOVE AIR REFINER ELEMENT


    1. A01WB0CC01
      B0069FO Remove in this Direction

      for Automatic Air Conditioning System:

      Remove the air refiner element.

    2. A01WB3NC01
      B0069FO Remove in this Direction

      for Manual Air Conditioning System, Manual Cooler System:

      Remove the air refiner element.

  5. REMOVE BLOWER WITH FAN MOTOR SUB-ASSEMBLY


    1. A01LAE0

      for Automatic Air Conditioning System:

      Remove the 3 screws and blower with fan motor sub-assembly.

    2. A01WAUE

      for Manual Air Conditioning System, Manual Cooler System:

      Remove the 3 screws and blower with fan motor sub-assembly.

  6. REMOVE NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)


    1. A01W961

      Remove the 2 screws and No. 1 blower damper servo sub-assembly.

  7. REMOVE AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System, Manual Cooler System)


    1. A01W8AB

      Detach the claw and remove the air inlet damper control cable sub-assembly.