| DTC Code | DTC Name |
|---|---|
| B22E5 | Sub Battery Module Low Voltage |
DESCRIPTION
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Memory |
|---|---|---|---|---|---|
| B22E5 | Sub Battery Module Low Voltage | This DTC is stored when the voltage of the sub-battery is lower than standard value continuously for 10 seconds. (1 trip detection logic) |
Charging system | Does not come on | DTC stored |
Tech Tips
The details of a DTC can be checked by using the DTC Sub Code of the freeze frame data that was recorded when the DTC was output.
| DTC Sub Code | Detail |
|---|---|
| "29" | Difference between VL01 Voltage and VL03 Voltage is less than 8.0 V |
WIRING DIAGRAM
| *a | Sub-battery Module Assembly | - | - |
| *1 | Sub-battery (Hi) | *2 | Sub-battery (Low) |
| *3 | Sub-battery | *4 | Voltage detection circuit |
| *5 | CPU | - | - |
CAUTION / NOTICE / HINT
Tech Tips
Read freeze frame data using the GTS. Freeze frame data records the sub-battery module assembly condition when malfunctions are detected.
PROCEDURE
INSPECT CHARGING SYSTEM
Inspect charging system.
| Result | |||
|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE CHARGING SYSTEM |
| OK |
|
CHARGE SUB-BATTERY MODULE ASSEMBLY
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Clear the DTCs.
Turn the engine switch off and wait for at least 30 seconds.
Turn the engine switch on (IG) and turn the GTS on.
Enter the following menus: Body Electrical / Sub Battery Module / Data List / Sub Battery Module State of Charge.
| Tester Display |
|---|
| Sub Battery Module State of Charge |
Start the engine and while idling, perform charging until the "Sub Battery Module State of Charge" reaches at least 20%*.
Tech Tips
*: Depending on the current charge of the sub-battery, it may take more than 30 minutes for the SOC (State of Charge) to reach 20% or more.
| Result | ||
|---|---|---|
|
| NEXT |
|
END |