DIFFERENTIAL CASE REASSEMBLY

PROCEDURE

  1. INSTALL FRONT DIFFERENTIAL SIDE GEAR

    1. C117507

      Coat the rotating surface of the front differential side gear with gear oil.

    2. Install the 2 front differential side gears and 2 front differential side gear thrust washers to the front differential case.

  2. INSTALL FRONT DIFFERENTIAL PINION

    1. C083566

      Coat the rotating surface of the front differential pinion with gear oil.

    2. Install the 2 front differential pinion thrust washers and 2 front differential pinions to the front differential case.

      Tip:

      Install the 2 front differential pinions with the front differential washers while turning the front differential pinion.

    3. C117493

      Install the No. 1 front differential pinion shaft into the front differential case.

    4. C117494

      Using a 5 mm pin punch and hammer, install the front differential pinion shaft straight pin through the front differential case and the hole in the No. 1 front differential pinion shaft.

    5. C117495

      Using a hammer and chisel, caulk the pin holes around the circumference of the front differential case.

  3. INSTALL FRONT DIFFERENTIAL RING GEAR

    1. Clean the contact surfaces of the front differential case and front differential ring gear.

    2. Heat the front differential ring gear to 90 to 110°C (194 to 230°F) in boiling water.

    3. C117489C03

      *a

      Matchmark

      After the moisture on the ring gear has completely evaporated, quickly align the matchmarks on the front differential ring gear and the front differential case and install the front differential ring gear to the front differential case.

    4. Install the 16 bolts.

      106 N*m

      1081 kgf*cm

      78 ft.*lbf

  4. INSTALL FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING

    1. C117497E02

      Using SST and a press, press in a new front differerntial case front tapered roller bearing.

      09308-14010

  5. INSTALL FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING

    1. C133923C01

      *a

      Press

      Using SST and a press, press in a new rear tapered roller bearing.

      09554-22010